FP715SI
8
GB
AB Copy: The AB copy function is available in 5+2 mode only and
only if activated in the Advanced Programming setting.
A and B days, when selected, can be any group of days e.g. 5+2,
4+3 etc. The days do not have to run in sequence. For example, to
operate in a 5+2 day mode the days can be set as follows:
To use the AB copy function – press the PROG button:
1. This will show the “A” days, with all the days selected.
2. Use the DAY button to highlight a day.
3. Subsequent presses of the DAY button will increment through
the days.
4. Press the + button to select a specifi c day as an “A” day, or press
the – button to specify a day as a “B” day.
5. Once the day has been selected as an “A” or “B” day the programme
will automatically jump to the next day.
6. When the last day of the week is active, pressing +, -, or DAY will
move back to the “A” days displayed with no selected (fl ashing)
days (see image below).
7. Repeat 2 to 6 until all selections have been made.
8. When selections are completed, press the PROG button to move
to event programming.
Event Programming in AB mode
1. Programme “A” day events using the + (time advance), - (time
decrease), and NEXT (next period) buttons.
2. Press the DAY button to change to programme the “B” days.
3. Programme “B” day events using the + (time advance), - (time
decrease), and NEXT (next period) buttons.
A Days B Days
Mon Tues Thurs Fri Sat Wed Sun
To Next Page
Loading...
Need help?
General
