Danfoss Heating
15
GB
The grey buttons next to the radiator symbol are the
Heating override buttons.
The grey buttons next to the tap symbol are the Hot
Water override buttons.
+1HR Pressing this button when either system is in AUTO
or ALLDAY mode will cause the heating/hot water to
remain on for an extra hour. If it is pressed while the
programme is OFF the heating/hot water will come on
immediately for 1 hour then go off again. +1HR will be
shown in the display.
MAN Pressing this button when either system is in AUTO or
ALLDAY mode will cause the heating/hot water to go
OFF until the next programmed ON, or vice versa. MAN
will be shown in the display.
Sometimes you may need to change the way you use your heating
temporarily, i.e. due to unusually cold weather. The FP715 Si has two
convenient overrides which can be selected without aff ecting the set
programme.
+1HR
MAN
+1HR
MAN
+1HR
MAN
+1HR
MAN
2.0 Advanced Settings
2.1 Temporary Override Buttons
To Next Page
Loading...
Need help?
General
