Danfoss Heating
15
GB
To perform a standard copy operation:
a) Press CH to select the channel.
b) Press PROG to go to event programming.
c) Press DAY/HOL to select the day to copy to.
d) Press COPY/i to copy the previous day’s events to the displayed
day.
Advanced Copy
The Advanced Copy function is available in 7 day mode only. This
allows any day to be copied to any other day, or days.
To use the Advanced Copy function, go into the event programming
using the PROG button, then:
1) Press DAY/HOL to select the day to be copied from.
2) Press COPY/i to copy from the selected day.
When selected, the day will begin to ash.
3) Press DAY/HOL to select the day to be copied to.
4) Press COPY/i to copy to the selected day.
5) Repeat steps 3 and 4 to select and copy other days.
6) To stop copying, use the DAY/HOL button to go back to the
ashing day and press the COPY/i button. The previously
ashing day will stop ashing to indicate it has been de-selected.
NOTE: When a day has been copied to, it will remain visible and not
ashing when the DAY/HOL button is used to select other days.
Channel Copy
Channel Copy is used to copy events from one channel to another
channel.
To perform a Channel Copy operation:
a) Press CH to select the channel to copy to.
b) Press COPY/i to copy from the previous channel.