FP735SI
6
GB
GB
FP735Si is delivered with a set of parameters that have been pre-
programmed to cover the most typical type of installations. See
(5.0). If a di erent parameter setup is wanted the unit provides two
programming options:
4.0 Programming Options
4.1 Normal programming
Normal Programming is meant for setting the timing pro le that
controls the ON and OFF periods for the room heating and for the hot
water. A daily pro le may be programmed and a pro le can control
the entire week where the weekend may be handled separately. Also a
timing pro le for a holiday can be entered.
As part of the normal daily operations, a simple one-button press
(+HRS) can extend a running ON period for room heating and/or hot
water by one hour. This can be repeated 3 times giving up to 3 hours
extension.
3.4 Mount the unit on the wallplate
3.5 With the unit powered up, it is recommended to press and
release the RESET button to start up the FP735Si unit.
Note: Always switch
the mains o rst
and never t/remove
the timer to/from a
live wallplate.
To Next Page
Loading...
Need help?
General
