1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
e30bg441.10
0.0
275 (10.8)
208 (8.2)
203 (8.0)
64 (2.5)
45 (1.8)
172 (6.8)
178 (7.0)
195 (7.7)
330 (13.0)
465 (18.3)
488 (19.2)
482 (19.0)
5x Ø 4 (0.2)
Illustration 9: FA10 Base Plate Template
2.7 Mounting the Frequency Converter
To install the mounting plate and frequency converter in the Rittal cabinet, use the following steps. Refer to Illustration 10.
Procedure
Attach the mounting plate to the cabinet rails, making sure that the pem nuts face the back of the cabinet.
Remove the backing paper from the self adhesive on the cutout gasket.
Affix the gasket over the duct opening in the mounting plate.
Remove the backing paper from the self adhesive on the strip gasket.
Affix the gasket over the lower 2 pem nuts in the mounting plate.
Remove the backing paper from the 2 seal plate gaskets, and affix the gaskets to the seal plates, 1 per plate.
Fasten 2 M10x30 screws through the seal plates, 1 per plate, and into the pem nuts at the lower end of the mounting plate.
Make sure that the screws are secure. The base of the frequency converter rests on the screws.
Slightly lean the top of the frequency converter forward and set the cutouts in the base onto the 2 screws.
Slowly push the top of the frequency converter back against the mounting plate until the top 2 pem nuts line up with the
holes in the frequency converter.
Secure the top of the frequency converter using 2 M10x30 screws.
Torque all M10x30 screws to 19 Nm (170 in-lb).
AN371942757356en-000101 / 136R025212 | Danfoss A/S © 2022.03
Installation
In-bottom/Out-back Cooling Kit for FA09-FA10
Installation Guide
To Next Page
Loading...
Need help?
General
