Danfoss ICAD 600B Installation Guide

© Danfoss | Climate solutions | 2023.09
4 | AN461947453648en-000101
Power on & start operation
ICAD has a light guide viewable from three sides, which indicates the status. Immediately after power on the light guide and display
lights up.
Data communication
Power supply
Control signals
The main screen layout and navigation is as described below. ICAD will start up in alarm mode as the ICM conguration needs to be
dened to start operation. Follow the steps on next page to set this up correctly.
ICAD name
Status
Actual opening degree
STATUS BARSTATUS BAR
Alarm | Warning | Service overdue | Modbus address | Bluetooth ON | UPS enabled
Back one level
On main screen show alarms
ARROW UP
Navigate up
Show I/O status
ARROW DOWN
Navigate down
Show I/O status
ENTER
Open menu / Down one level
Set parameter on lowest level
EXIT
ENGLISH
Light guide
Steady red Critical alarm - stopped operating
Flashing red Severe alarm - danger of stopping operating
Flashing blue ICAD is connected via Bluetooth
Flashing yellow Warning
Flashing green OK

Danfoss ICAD 600B Specifications

General

Brand	Danfoss
Model	ICAD 600B
Category	Control Unit
Language	English