4
Installation
· First, remove the wallplate from the back of the unit.
· From the top left hand corner of the wallplate, there must be
clearances of at least 150mm to the right, 15mm to the left, 30mm
above and 100mm below in order to mount the plug-in module.
· Fix at a height of approximately 1.5m from the fl oor, away from
draughts or heat sources such as radiators, open fi res or direct
sunlight.
Thermostat Wiring
1
OFF
23
COM ON
N/C
N/O
Installation Instructions
GB
!
Some existing thermostats will have a Neutral and/or Earth wire connected.
These are not required by the TP4000 and must NOT be connected to any TP4000
terminals. Instead they should be made electrically safe and coiled in the recess at
the back of the TP4000.
To Next Page
Loading...
Need help?
General
