8
Before you start
Open the fl ap on the front of the
programmer.
Press the + & – AND & buttons
simultaneously to reset the unit.
This will reinstate the preset
programmes and will set the time to
12:00 on Day 1 and the temperature
to 20°C.
Setting the Clock & Day
Note: clock is displayed in 24 hour mode
CLOCK
Press PROG to begin programming.
Use + or - to adjust the TIME
(press and hold to change in 10 min
increments)
DAY
Press PROG again.
Use + or - buttons until correct DAY is
shown (1 = Monday, 2 = Tuesday, etc)
Remember - you will have to
reset the time when the clocks
change in Spring and Autumn.
i2 00
!
GB - User Instructions
To Next Page
Loading...
Need help?
General
