Danfoss VLT 2800 Series User Manual

Parameter list with factory settings
PNU # Parameterdescription Factory setting 4-setup Conv.
index
Data
type
001 Language English No 0 5
002 Local/remote operation Remote-controlled Yes 0 5
003 Local reference 000,000.000 Yes -3 4
004 Active Setup Setup 1 No 0 5
005 Programming Setup Active Setup No 0 5
006 Setup copying No copying No 0 5
007 LCP copy No copying No 0 5
008 Display scaling 1.00 Yes -2 6
009 Large display readout Frequency [Hz] Yes 0 5
010 Small display line 1.1 Reference [%] Yes 0 5
011 Small display line 1.2 Motor current [A] Yes 0 5
012 Small display line 1.3 Power [kW] Yes 0 5
013 Local control Remote control
as par. 100
Yes 0 5
014 Local stop/reset Active Yes 0 5
015 Local jog Not active Yes 0 5
016 Local reversing Not active Yes 0 5
017 Local reset of trip Active Yes 0 5
018 Data change lock Not locked Yes 0 5
019 Operating status at
power up
Forced stop,
use saved ref.
Yes 0 5
020 Lock for Hand mode Active No 0 5
024 User-defined Quick Menu Not active No 0 5
025 Quick Menu Setup 000 No 0 6
4-Setup:
'Yes' means that the parameter can be programmed
individually in each of the four Setups, i.e. one single
parameter can have four different data values. 'No'
means that the data value will be the same in all Set-
ups.
Conversion index:
This number refers to a conversion figure to be used
when writing or reading via serial communication with
a frequency converter.
See Data character in Serial communication in the VLT
2800 Design Guide.
Data type:
Data type shows the type and length of the telegram.
Data type Description
3 Integer 16
4 Integer 32
5 Unsigned 8
6 Unsigned 16
7 Unsigned 32
9 Text string
VLT
®
2800 Series
MG.27.A2.02 - VLT
®
is a registered Danfoss trademark 93
All about VLT 2800

Danfoss VLT 2800 Series Specifications

General

Brand	Danfoss
Model	VLT 2800 Series
Category	DC Drives
Language	English