Title Literature no.
VLT 2800 Operating Instructions MG.27.AX.YY
VLT 2800 Design Guide MG.27.EX.YY
VLT 2800 Data Sheet MD.27.AX.YY
Mounting Instruction for VLT 2800 MI.28.AX.YY
VLT 2800 Filter Instruction MI.28.BX.YY
Precise Stop MI.28.CX.YY
Cold Plate MI.28.DX.YY
VLT 2800 NEMA 1 Terminal Covering MI.28.EX.YY
VLT 2800 DeviceNet Cable MI.28.FX.YY
VLT 2800 Blue Star Condensing Unit MI.28.GX.YY
VLT 2880 - 2882 Spare Part Instruction MI.28.HX.YY
Wobble Function MI.28.JX.YY
VLT 2800 LCP Remote-mounting Kit MI.56.AX.YY
User Instruction for LOP MI.90.EX.YY
Brake Resistor MI.90.FX.YY
Profibus DP Manual MG.90.AX.YY
VLT 2800 DeviceNet Manual MG.90.BX.YY
Metasys N2 Manual MG.90.CX.YY
Profibus Manual MG.90.EX.YY
Output Filter Manual MG.90.NX.YY
Brake Resistor Manual MG.90.OX.YY
MCT-10 Manual MG.10.RX.YY
Modbus RTU Manual MG.10.SX.YY
Protection against Electrical Hazards MN.90.GX.YY
X = Revision Number, Y = Language code
Application notes can be found on
Danfoss website under BusinessAreas/DrivesSolutions/Doc-
umentations/Technical+Documentation.htm
1.2.3 Approvals
1.2.4 Disposal Instruction
Equipment containing electrical components must not be disposed of
together with domestic waste.
It must be separately collected with electrical and electronic waste
according to local and currently valid legislation.
1.3 Mechanical Installation
VLT 2800 frequency converters allow side-by-side installation on a wall in any position as the units
do not require ventilation on the side. Because of the need for cooling, there must be 10 cm free
air passage above and below the frequency converter.
All units with enclosure IP 20 must be integrated in cabinets and panels. IP 20 is not suitable for
remote mounting. In some countries, e.g. in the USA, units with enclosure NEMA 1 are approved
for remote mounting.
1 Quick Guide VLT 2800 Quick Guide
4
MG.28.M1.02 - VLT
®
is a registered Danfoss trademark
1
To Next Page
Loading...
Need help?
General