Danfoss VLT 5000 Application Note

MN.51.T1.02 - VLT is a registered Danfoss trademark2
VLT
®
5000 DeviceNet and Allen Bradley Control logix 5550
NOTE!:
The examples do not describes all the
functions needed for a real application, for
example error handling.
The examples are based upon that a RS Logix5000
project has been created, and the 1756-DNB has
been added to the I/O configuration.
Details of some of the components/software:
VLT5000 with DeviceNet - Host chip version 2.9.
1756-DNB Series A Firmware Revision 3.3
RS Networx 2.11.51
RS Logix 2.25
■■
■■
■ Foreword
This application note describes how to set up
DeviceNet communication between a Danfoss VLT
5000 frequency converter and 1756-DNB DeviceNet
Scanner from Allen Bradley. It is assumed that you
have some knowledge of Control Logix 5550, the
1756-DNB Scanner and ladder logic.
This note describes:
● VLT 5000 DeviceNet card
● Configuring of the VLT 5000 with RS Networx
● I/O communication with RS Logix 5000
● Explicit messages with RS Logix 5000
Device status
LED
Revisions number
18115D
■■
■■
■ VLT 5000 DeviceNet card
The photo shows the DeviceNet card which can
be installed in VLT 5001 - 5500.
Network status
LED
Device status
LED
Network status
LED
Address switch and
baud rate setting
ON = 0
OFF = 1

Danfoss VLT 5000 Specifications

General

Brand	Danfoss
Model	VLT 5000
Category	Controller
Language	English