Danfoss VLT 5006 Operating Instructions

VLT
®
5000 Series
Safety
175ZA438.18
VLT 5000 Series
Operating Instructions
Software version: 3.7x
These Operating Instructions can be used for all VLT 5000 Se-
ries frequency converters with software version 3.7x.
The software version number can be seen from parameter 624.
CE and C-tick labelling do not cover VLT 5001-5062,
525-600 V units.
These Operating Instructions are a too
l intended for persons who are to install, operate and program the
VLT 5000 Series.
Operating Instructions: Gives instructions in optimum installation, commissioning and service.
Design Guide: Gives all required information for design purposes, and gives a good
insight into the technology, product range, technical data, etc.
The Operating Instructions including Quick Setup are delivered with the unit.
When reading these Operating Instructions, you will come across different symbols that require special
attention.
The symbols used are the following:
Indicates a general warning
NB!:
Indicates something to be noted by the reader
Indicates a high-voltage warning
MG.51.A9.02 - VLT is a registered Danfoss trademark
3

Danfoss VLT 5006 Specifications

General

Brand	Danfoss
Model	VLT 5006
Category	DC Drives
Language	English