VLT 5000 Series
Instruction Manual
Software version: 3.9x
This Instruction Manual can be used for all VLT 5000 Series adjustable frequency drives with software version
3.9x.
The software version number can be seen from parameter 624.
CE and C-tick labeling do not cover VLT 5001-5062, 525-600 V units.
The VLT Adjustable Frequency Drive con-
tains dangerous voltages when connec-
ted to line voltage. After disconnecting
from the line wait at least 15 minutes be-
fore touching any electrical components.
Also make sure that other voltage inputs
have been disconnected, such as external
24 VDC, load-sharing (linkage of DC in-
termediate circuit), as well as the motor
connection for kinetic back-up. Only a
competent electrician should carry out the
electrical installation. Improper installa-
tion of the motor or the VLT may cause
equipment failure, serious injury or death.
Follow this manual and National Electrical
Codes (NEC®) and local safety codes.
NOTE
Electrostatic Precaution; Electrostatic dis-
charge (ESD). Many electronic compo-
nents are sensitive to static electricity.
Voltages so low that they cannot be felt,
seen or heard, can reduce the life, affect
performance, or completely destroy sen-
sitive electronic components. When per-
forming service, proper ESD equipment
should be used to prevent possible dam-
age from occurring.
It is the responsibility of the user or the
person installing the VLT to provide prop-
er grounding, as well as motor overload
and branch circuit protection according to
the National Electrical Code (NEC®) and
local codes.
By altitudes above 2000 m, please contact
Danfoss Drives regarding PELV.
VLT
®
5000 Series
4 MG.51.C5.22 - VLT
p
is a registered Danfoss trademark.
To Next Page
Loading...
Need help?
General