VLT
®
FCD Series
■ Factory settings
PNU
#
Parameter
description
Factory setting Changes
during
operation
4-setup Conv.
index
Data
type
001 Language English Yes No 0 5
002 Local/remote operation Remote-controlled Yes Yes 0 5
003 Local reference 000,000.000 Yes Yes -3 4
004 Active Setup Setup 1 Yes No 0 5
005 Programming Setup Active Setup Yes No 0 5
006 Setup copying No copying No No 0 5
007 LCP copy No copying No No 0 5
008 Display scaling 1.00 Yes Yes -2 6
009 Large display readout Frequency [Hz] Yes Yes 0 5
010 Small display line 1.1 Reference [%] Yes Yes 0 5
011 Small display line 1.2 Motor current [A] Yes Yes 0 5
012 Small display line 1.3 Power [kW] Yes Yes 0 5
013 Local control Remote control
as par. 100
Yes Yes 0 5
014 Local stop/reset Active Yes Yes 0 5
015 Local jog Not active Yes Yes 0 5
016 Local reversing Not active Yes Yes 0 5
017 Local reset of trip Active Yes Yes 0 5
018 Data change lock Not locked Yes Yes 0 5
019 Operating status at
power up
Forced stop,
use saved ref.
Yes Yes 0 5
020 Lock for Hand mode Active Yes No 0 5
024 User-defined Quick Menu Not active Yes No 0 5
025 Quick Menu Setup 000 Yes No 0 6
026 LED Status Overload Yes Yes 0 5
4-Setup:
’Yes’ means that the parameter can be programmed
individually in each of the four Setups, i.e. one single
parameter ca
n have four different data values. No’
means that the data value will be the same in all Setups.
C
onversion index:
This number refers to a conversion figure to be used
when writ
ing or reading via serial communication
with a frequency converter.
Conversion table
Conversion
index
Conversion
factor
73 0.1
2 100
110
01
-1 0.1
-2 0.01
-3 0.001
-4 0.0001
-5 0.00001
See also Serial communication.
D
ata type:
Data type shows the type and length of the telegram.
Data type Description
3 Integer 16
4 Integer 32
5 Unsigned 8
6 Unsigned 16
7 Unsigned 32
9Textstring
MG.04.B7.02 - VLT is a registered Danfoss trademark
118
To Next Page
Loading...
Need help?
General