Danfoss VLT FCD 305 User Manual

VLT
®
FCD Series
Initialisati on [3] is selected if you wish to use
the unit’sfactorysetting.
Procedure for initialisation:
1. Select Initialisation [3].
2. Disconnect the mains voltage and wait until the
light in the display has disappeared.
3. Connect the mains voltage.
4. An initialisation is performed in all parameters
in all Setups, with the exception of parameters
500 Address, 501 Baudrate, 600-605 Operating
data and 615-617 Fault log.
✭ = factory setting. () = display text [] = value for use in communication via serial communication port
MG.04.B7.02 - VLT is a registered Danfoss trademark
98

Danfoss VLT FCD 305 Specifications

General

Frequency	50/60 Hz
Enclosure	IP20
Input Voltage	380-480 V
Communication	RS485, CANopen, Profibus
Protection Features	Overcurrent, overvoltage, undervoltage, overload, short circuit, overtemperature
Brake Function	Integrated brake chopper