Danfoss VLT MCD 201 Installation Guide

1.
2.
-
3 Installation
3.1 Installing the Communication Module
C A U T I O N
EQUIPMENT DAMAGE
If mains and control voltage are applied when installing or removing options/accessories, it may damage the equipment.
Remove mains and control voltage from the soft starter before installing or removing options/accessories.
Procedure
Remove control power and mains supply from the soft starter.
Fully pull the top and bottom retaining clips on the module.
e77ha833.10
AN427641276310en-000101 / 175R1187 | 9Danfoss A/S © 2022.10
Installation
EtherNet/IP Module
Installation Guide

Danfoss VLT MCD 201 Specifications

General

Brand	Danfoss
Model	VLT MCD 201
Category	Controller
Language	English