How to Scan
Quick Reference Guide 1-7
Resetting the Standard Product Defaults
If programming settings for your scanner are in an unknown condition,
factory settings can be restored by scanning the “Standard Product
Default Settings” bar code below. A listing of factory default settings is
available in the PRG. Settings can vary, depending upon the interface
type.
How to Scan
When the trigger is pressed, the scanner projects a red, horizontal illumi-
nating beam. This beam will remain on until the trigger is released, a bar
code is read, or until a time-out
1
period expires.
Keyboard
Wedge V
Keyboard
Wedge W
Keyboard
Wedge X
1. Reference the Product Reference Guide (PRG) for more information about the aiming
beam time-out period.
NOTE
If the surface being scanned is highly reflective
(e.g., laminated), it may be necessary to tilt the item
or the scanner slightly (15° to 18°) to prevent
unwanted reflection.
Standard Product Default Settings
To Next Page
Loading...
Need help?
General
