8
Bi-Wiring
The concept of bi-wiring is that higher sonic performance (greater inner detail,
higher definition, increased transparency and improved depth) is achieved by
utilizing two sets of wires to connect each loudspeaker to its respective channel
of your amplifier or receiver.
If you choose this method of hook-up, follow these instructions:
For bi-wiring: (See Diagram # 2) Remove both the jumpers between the
low/mid and high terminals on each speaker. Then take care to ensure that both
the red (+) high and red (+) mid terminals of the left speaker are connected to the
red (+) terminal of the left channel of your amplifier (each using one conductor of
each of the two sets of wires for the left channel) and that both the black (-) high
and black (-) low/mid terminals of the left speaker are connected to the black (-)
terminal of the left channel of your amplifier using the other conductor of each of
the two sets of wires for the left channel. Utilize the same hook-up procedure for
the right channel.
+
-
Left Right
Left Speaker
Right Speaker
Power Amplifier
or Receiver
Diagram # 2: Bi-Wiring
To Next Page
Loading...
Need help?
General
