Unpacking Your
Mythos
Loudspeakers
Please Inspect For Shipping
Damage
Each loudspeaker leaves our plant
in
perfect condition.
Any
visible or
concealed damage most likely occurred
in
handling after
it
left
our plant
and should
be
reported
at
once
to
your Definitive dealer or
the
delivery
company
that
delivered your loudspeaker. Please
unpack
your system
carefully.
Save
all
cartons
and
packing materials
in
case
you
move or
need
to
ship
your system. Record
the
serial number
found
on
the
back of
the
Mythos loudspeakers
in
the
appropriate
place
on
your warranty
card.
Base
Installation Instructions
Tools
required:
4mm (or 5/32")
Allen
Wrench
(also called
Hex
Key
driver) (not supplied)
Parts
required:
Tempered Glass Base (supplied),
four
Allen head bolts
(supplied), 8 plastic washers (supplied)
Instructions:
1.
Carefully
lay
the
Mythos on
its
side.
Lift
the
base ofthe speaker about
six
inches
and
support it with a soft padded object,
such
as
a
pillow.
Do
NOT
support
the
speaker
with
a hard object,
as
you
might dent
or
scratch
the
aluminum
finish.
2.
Place
one
plastic washer
on
each bolt.
3.
Insert
the
bolts
into
the
glass base
from
the
same
side
that
the
silver
feet
are
attached
to.
4.
Place another plastic washer
on
each bolt
so
the
washer
is
against
the
glass.
5.
Finger tighten
all
four bolts
into
the
threaded holes
on
the bottom of
the
Mythos.
If
this
has
been done correctly, washers
will
be
between
the
metal surface of
the
Mythos,
the
glass,
and
the
heads ofthe bolts.
6.
GENTLY
tighten each bolt
with
the
Allen
head
wrench.
Do
NOT
overtighten or
you
may
crack
the
glass.
7.
Note
the
label
showing the height adjustment ring
and
locking collar
on
the
silver
feet.
Carefully return
the
speaker
to
the
upright position
and
adjust
the
feet
to
level
the
speaker.
To Next Page
Need help?
General
