Getting Started Guide 5
Introduction
This document provides basic information about the Dell EMC Networking
N3000ET-ON/N3000EP-ON switch, including how to install a switch and
perform the initial configuration. For information about how to configure and
monitor switch features, refer to the User Configuration Guide, which is
available on the Dell EMC Support website at dell.com/support. See the
Support website for the latest updates on documentation and firmware.
NOTE: Switch administrators are strongly advised to maintain Dell EMC
Networking switches on the latest version of the Dell EMC Networking Operating
System (DNOS). Dell EMC Networking continually improves the features and
functions of DNOS based on feedback from you, the customer. For critical
infrastructure, pre-staging of the new release into a non-critical portion of the
network is recommended to verify network configuration and operation with the
new DNOS version.
N3000ET-ON/N3000EP-ON Hardware Overview
This section contains information about device characteristics and modular
hardware configurations for the Dell EMC Networking N3000ET-ON/
N3000EP-ONswitch.
Power Consumption and Power Budget for the N3024EP-ON and
N3048EP-ON PoE Switches
Table 1-1 describes the power consumption for the N3024EP-ON and
N3048EP-ON PoE switches.
Table 1-1. Power Consumption for the N3024EP-ON/N3048EP-ON PoE Switch
Model Input Voltage Power Supply
Configuration
Maximum Steady
Current
Consumption (A)
Maximum
Steady
Power (W)
N3024EP-ON/
N3048EP-ON
100V/60Hz PSU1 + PSU2 21.8 2180.0
110V/60Hz PSU1 + PSU2 19.5 2145.0
120V/60Hz PSU1 + PSU2 17.8 2136.0
220V/50Hz PSU1 + PSU2 9.31 2048.2
240V/50Hz PSU1 + PSU2 8.6 2064.0
To Next Page
Loading...
Need help?
General