Procedure to move the screw mount
About this task
This computer supports two solid-state drive form factors:
● M.2 2230
● M.2 2280
If you are replacing the solid-state drive of a different form factor other than the one removed, see the following procedure to
move the location of the screw mount.
Steps
1. Remove the screw mount from the palm-rest and keyboard assembly.
2. Turn the screw mount to 180 degrees.
3. Insert the screw mount into the other screw mount slot on the palm-rest and keyboard assembly.
4.
To install 2230 solid-state drive, see installing 2230 solid-state drive.
5. To install 2280 solid-state drive, see installing 2280 solid-state drive.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image indicates the location of the wireless card and provides a visual representation of the removal procedure.
Removing and installing components
25
To Next Page
Loading...
Need help?
General
