Using Your Projector 35
6 Power Turns the projector on or off. For more
information, see "Turning Your Projector On" on
page 29 and "Turning Your Projector Off" on
page 29.
7 Down / Keystone
adjustment
Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to adjust image distortion caused by tilting
the projector (+40/-35 degrees).
8 LAMP warning light If the LAMP amber indicator is on or blinking,
one of the following problems could be occurring:
• Lamp is reaching its end of usable life
• Lamp module is not properly installed
• Lamp driver failure
• Color wheel failure
For more information, see "Troubleshooting Your
Projector" on page 108 and "Guiding Signals" on
page 114.
9 TEMP warning light If the TEMP amber indicator is on or blinking,
one of the following problems could be occurring:
• Internal temperature of the projector is too
high
• Color wheel failure
For more information, see "Troubleshooting Your
Projector" on page 108 and "Guiding Signals" on
page 114.
10 Enter Press to confirm the selection item.
http://www.pureglare.com.au
To Next Page
Loading...
Need help?
General
