Back to Contents Page
System-Board Shield
Dell™Vostro™320ServiceManual
Removing the System-Board Shield
NOTE: You may need to install Adobe®Flash®Player from Adobe.com to view the following illustrations.
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the front panel.
3. Remove the internal panel.
4. Remove the I/O cover.
5. Remove the hinged stand.
6. Remove the optical drive.
7. Remove the back cover.
8. Remove the back metal-shield.
9. Remove the screw that secures the system-board shield to the computer.
10. Rotate the computer 90-degrees.
11. Remove the screws that secure the system-board shield to the side of the computer.
12. Remove the inverter board cable from the routing on the system-board shield.
13. Lift the system-board shield from the computer.
Replacing the System-Board Shield
To replace the system-board shield, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
To Next Page
Loading...
Need help?
General
