7
134
3
in the
window
panel
in the wooden
kickboard of a
French window
in the wall:
you are
recommended to
insulate the section
of wall using suita-
ble insulation.
• Fit the wall ange B1 into the hole.
• Screw the wall mounting accessory B4 into the hose B2.
and t it into the wall ange B1.
• When the hose B2 is not connected, the drilled hole can be
closed with the ange cap B1.
NOTE:
• As special tools are required for installation, we sug-
gest you have the appliance installed by specialized
personnel.
• When installing the air conditioner, you should leave a door
slightly open as little as 1/2“ (1 cm) to guarantee correct
ventilation and room pressure.
• Keep the air hoses as short and free of curves as possible to
avoid constrictions.
AIR CONDITIONING WITHOUT INSTALLATION
You can also set up in a double-hung window:
• Place the window bracket in the window sill, extend the
bracket fully within the window frame, x the bracket by
using the pin then lower the window onto the bracket.
(Should the window bracket be too large for the window
the plastic can be cut with a saw by a qualied profes-
sional)
• Screw the hose adaptor B3 to the hose’s end B2.
• Fit the air exhaust hose B2 in the relevant housing located
on the rear side of the appliance (g. 1).
• Connect the window outlet B7 to the other end of the ex-
haust hose.
• Insert the window outlet end of the exhaust hose into the
slot of the window bracket (g. 4).
4
Other set up methods:
• Thanks to the locking pins, it’s possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust hose
(see gure 5).
5
If you have a casement window (gure 6) proceed as follows:
• Screw the hose adaptor B3 to the hose’s end B2.
• Fit the air exhaust hose B2 in the relevant housing located
on the rear side of the appliance (g. 1) then, place the
window outlet B7 outside the window to exhaust the hot
air.
6
To Next Page
Loading...
Need help?
General
