To Next Page

To Previous Page

1) Remove the continuous drain cap 1 by turning

it counterclockwise then remove the rubber

stopper from the spout 2 (fig. 2).

2) Insert the drain cap 1 in the condensate drain

hose (8) till the end (fig. 3) then screw the

cap into the spout. (fig. 4).

3) Make sure the end of the hose is no higher

than the spout (Fig. 3) or water could remain

in the tank. Make sure there are no kinks in

the hose (Fig. 5).

Keep the rubber stopper to close

the spout.

C) Continuous draining using the

pump (only on pump models)

The patented heavy-duty pump system allows

water removal of up to 13 ft (4m) in height.

If you want the water to flow directly to a drain,

connect the condensation discharge tube supplied

(9) to the connection pipe located on the

lower front part of the unit unit (you will first need

to remove the stopper labeled PUMP) (fig. 6).

Select the dehumidifying function and press the

PUMP button.

Note: With the condensation discharge hose

missing and the pump switched ON, the display

will show the symbol PUMP blinking.

To eliminate this problem:

• Check the hose is correctly positioned;

• Disconnect and reconnect the plug.

fig. 2

fig. 3

fig. 1

fig. 5

fig. 4

PUSH

fig. 6

DeLonghi DD40P User Manual

Questions and Answers: