1111
This cooker has class “2/1” overheating protection so that it can be installed next
to a cabinet.
If the cooker is installed adjacent to furniture which is higher than the gas hob cooktop, a
gap of at least 200 mm must be left between the side of the cooker and the furniture.
The walls and kitchen furniture surrounding the appliance must be made of non-ammable
material. The veneered synthetical material and the glue used must be resistant to a
temperature of 150°C in order to avoid ungluing or deformations. It is recommended that
a 10 mm gap to each side is made if the adjacent kitchen furniture is made of a plastic
laminate wrap.
Curtains must not be tted immediately behind appliance or within 500 mm of the sides.
It is essential that the cooker is positioned as stated below.
We do not recommend the cooker is located on a plinth. If this is unavoidable, it will be
necessary to provide safety measures to prevent the appliance falling o.
The cooker must be installed by a suitably qualied technician and in compliance
with local safety standards.
A marine application is not to be considered as a domestic enviroment.
1 - INSTALLATION
200 mm
650 mm
500 mm
450 mm
Fig. 1.1
To Next Page
Loading...
