17
Check that the two red buttons have snapped out, otherwise the door cannot be closed.
• Remove the milk spout (fig. 32) and the milk intake
tube.
• Remove the milk froth regulator by pulling it out-
wards.
•Wash the container and lid in hot soapy water.
Make sure there is no milk residue inside the two
holes in the lid of the milk container indicated by
the arrows in the figure or the milk intake tube.
• Replace the milk froth regulator, the milk intake
tube and the milk spouts.
• Clock
• Auto-start time
• Descaling process
• Coffee temperature
• Length of time the appliance remains on
•Water hardness
• Factory default values
• Language
CORRECT
INCORRECT
The two red buttons have
snapped out
CORRECTLY
The two red buttons have not
snapped out
NOTE 1: If the infuser is not inserted correctly, until it clicks into place, and the two red buttons have not
snapped out, the service door cannot be closed.
NOTE 2: If it is hard to insert the infuser, before inserting it, squeeze it to the right size by pressing it force-
fully from the top and bottom simultaneously, as shown in figure 31.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the outlet then plug in again. Wait for all the lights to go off, then open the door and replace the infuser.
•replace the drip tray, complete with the grounds container;
• close the service door.
15.3 Cleaning the milk container
Proceed as follows:
16 CHANGING AND SETTING THE MENU PARAMETERS
After pressing the button, when the appliance is ready, you can use the internal menu to modify the fol-
lowing parameters and functions:
To Next Page
Loading...
Need help?
General
