WATER FILTER
Please note! The filter lasts about two
months if the appliance is used normally.
If the coffee maker is
left unused with
the filter installed, it will last a maximum
of three weeks.
11
A C D EB
Installing the filter
1. Remove the filter from the
packaging.
2. Turn the date indicator disk
(A) until the next 2 months of
use are displayed.
3. To activate the filter, put it
under tap water until water
overflows the side openings
for more than 1 minute (B).
4. Remove the tank from the
appliance and fill with water.
5. Insert the filter in the water
tank and immerse it completely
for ten or so seconds, sloping
it to enable the air bubbles to
escape (C).
6. Insert the filter in the filter
housing (D) and press as far as it will go.
7. Close the tank with the lid (E), then place
the tank in the machine.
8.
Place a container with a
minimum capacity of 16.91 oz.
/ 500 ml under the hot water/
steam spout.
9.
Turn the hot water/steam dial
in position I to deliver hot water.
10.
Let the appliance deliver hot
water, until the delivery flows reg-
ulary (min 16.91 fl. oz/500ml),
then turn the dial in position 0.
Please note:
It may happen that a single hot
water is not sufficient to install the
filter: the lights come on.
In this case, repeat the installing
operation from step 8. The new filter
is active and you can now use the
coffee maker.
To Next Page
Loading...
Need help?
General
