8
SELECT THE TEMPERATURE SCALE
The temperature can
be displayed in °C or °F.
To change the temper-
ature unit of measure
touch both the in-
crease
(C3) and
decrease C4) keys
for about 10 seconds.
OPERATING FROM THE REMOTE CONTROL
INSERTING OR REPLACING THE BATTERIES
• Remove the cover on the rear of the remote control;
• Insert or replace the batteries with two new LR03 “AAA”
1.5V batteries, inserting them correctly (see the directions
inside the battery compartment) (g. 7);
• Replace the cover.
7
max
23ft/7 meters
Please note: If the remote control unit is replaced or discarded,
the batteries must be removed and disposed of in accordance
with current legislation as they are harmful to the environment.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium) batteries. Do not dispose of batteries in re.
Batteries may explode or leak. If the remote control is not be
used for a certain length of time, remove the batteries.
USING THE REMOTE CONTROL
• Point the remote control at the receiver no more than 23
feet (7 meters) away from the appliance (g. 7) without
obstacles between the remote control and the receiver.
• The remote control must be handled with care. Do not drop
it or expose it to direct sunlight or sources of heat.
Please note: The remote control can be safely stored in the ap-
propriate compartment (A11).
DESCRIPTION OF THE REMOTE CONTROL
D1. ON/STAND-BY button
D2. MODE button
D3. Decrease button
D4. Increase button
D5. Air ow selection button
D6. Swing button
D7. Timer button
D8. UV-Carelight button
D1
D3
D5
D7
D8
D6
D2
D4
TURNING THE APPLIANCE ON/OFF
• Plug into the outlet.
• Press the
C1C2
C4
C11
C13
C12
C9
C7
C5
C6
C3
C16
C14
C10
C15
C17
C8
button (D1) to turn the unit on.
When turned on, the air conditioner starts operating in the
same mode as when it was turned o .
• To switch the appliance o, press the
C1C2
C4
C11
C13
C12
C9
C7
C5
C6
C3
C16
C14
C10
C15
C17
C8
button (D1) .
Please note: Never switch the appliance o by removing the
plug. Always switch it o by pushing the
C1C2
C4
C11
C13
C12
C9
C7
C5
C6
C3
C16
C14
C10
C15
C17
C8
button and waiting
a few minutes before removing the plug. Only in this way will
the appliance be able to perform its standard checks.
SELECTING THE OPERATING MODES
To select the desired operating mode, press repeatedly the
MODE button (D2) until the desired function is selected.
Most of the commands available on the remote control corre-
spond to those on the appliance control panel (C).
SELECTING THE TEMPERATURE
In air conditioning mode, press (D3) and (D4) keys to de-
crease/increase the desired temperature.
SELECTING THE AIR FLOW
In air conditioning and fan modes, press (D5) button on re-
mote control to increase/decrease the desired air ow.
D