DeLonghi FAN HEATER Instruction Manual

3
ELECTRICAL CONNECTION
- Before plugging in the heater, check that the voltage of your domestic supply corresponds
to the voltage (V) indicated on the rating label of the heater and that the socket and power
line are appropriately dimensioned.
- THIS APPLIANCE COMPLIES WITH EEC DIRECTIVE 89/336, RELATING TO ELECTRO-
MAGNETIC COMPATIBILITY.
-When you plug in the appliance, the red pilot light will illuminate (Fig. 1).
INSTALLATION
The appliance requires no installation; it should be used solely as a portable appliance on
an horizontal surface.
The appliance must be installed outside of the prescribed protective volume (Fig. 2) and in
any case away from bathtubs, showers, washbasins, taps, etc.
The appliance must not be positioned directly underneath a fixed power
point.
OPERATION AND USE
1) SETTING THE CLOCK
For the first time, set the clock to the correct time, proceeding as follows:
• Press the button “hour” until the display shows the hours for the correct time, then relea-
se the button (fig.1).
• Press the button “min” until the display shows the minutes for the correct time, then relea-
se the button (fig. 1).
When setting the correct time, the numbers will flash on the display.
The flashing of the numbers will continue for a few seconds after the adjustment has finished
then stop on the correct time and the clock start working.
(Keep both pushbuttons pressed for more than 3 seconds to move through the hours and minu-
tes in fast mode).
To change the time, press pushbuttons “hour” for at least 5 seconds, then proceed as above
to modify both hours and minutes.
2)ON/OFF FOOT SWITCH
This appliance is also fitted with a foot switch on the base. Press the foot switch (Fig.2) to start all
functions, including the timer function. When the foot switch is pressed, the pilot light on the
base will turn on. To switch it off, simply press the foot switch again (pilot light off ).
3)MANUAL FUNCTIONING
To operate the heater without timer press the “MANUAL FUNCTION” button. (Fig. 1). By
pressing the “MANUAL FUNCTION” button one or more times, the appliance will select the
operating heating power, as follows:
correct time
See rating label
Voltage Wattage
°C
AUTO
:
0
room temperature
Fig.3
foot switch pilot light

DeLonghi FAN HEATER Specifications

General

Brand	DeLonghi
Model	FAN HEATER
Category	Heater
Language	English