DeLonghi TRRS series User Manual

7 pages

To Previous Page

turn the numbered timer disk clockwise until the num-

ber 22 (10 p.m.) on the disk coincides with the pointer

s (3) on the timer. Set the periods of time when you

want the appliance to work by pushing the teeth (1)

inward.

Each tooth (1) corresponds to a period of 15 minutes.

This will leave visible sectors which correspond to the

periods of operation (2). When set, the radiator will

operate automatically each day during the times pro-

grammed (important: the radiator must always be

plugged into the socket).

- To change the programming, move the teeth back into

the initial position and set the new periods of operation.

- To turn the appliance o completely, as well as press the

switches to the 0 position, you must also unplug it from

the power outlet to avoid continued operation of the

timer.

IMPORTANT: DO NOT ROTATE CLOCK DIAL COUN-

TER-CLOCKWISE.

The timer is like an electric clock, and will only work when

plugged into a power supply. When unplugged, the timer

stops and must be later re-set.

Timer override (only on some models)

If you wish to override the timer settings, push the timer

switch to position I (g.8) manual (timer override). To return

to timed operation push the switch back to the middle posi-

tion (g.8).

NOTE: if the timer switch is at the 0 position (g. 8),

the heater is o and will not operate).

MAINTENANCE

Before carrying out any operation on the radiator, unplug

from the electric mains and wait for it to cool.

The oil-lled electric radiator requires no particular mainte-

nance. It is sucient to remove the dust with a soft, dry cloth.

Never use abrasive powders or solvents. If necessary remove

concentrations of dirt using a vacuum cleaner.

TECHNICAL CHARACTERISTICS

Power supply See rating label

Absorbed power “

TROUBLESHOOTING

PROBLEM CAUSE SOLUTION

The appliance doesn't work Be sure it is plugged in and that the elec-

trical outlet is working.

Check for any obstruction.

The temperature may be set too low.

Plug into the power outlet.

Remove the obstruction and let the appliance

cool down. If the appliance doesn't work

please contact Customer Experience.

Set the temperature to a higher position.

Questions and Answers:

M
Molly HarrisJul 26, 2025
What to do if my DeLonghi TRRS doesn't work?
- A
  Annette MurphyJul 26, 2025
  If your DeLonghi Heater isn't working, make sure it's properly plugged into a working electrical outlet. Check for any obstructions blocking the heater and allow it to cool down if necessary. Also, ensure the temperature isn't set too low; try increasing it. If these steps don't solve the issue, please contact Customer Experience.