4
UNPACKING AND CLEANING
Carefully unpack the drill press and all loose items from the shipping container(s). Remove the protective coating from
the machined surfaces of the drill press. This coating may be removed with a soft cloth moistened with kerosene. Do
not use acetone, gasoline or lacquer thinner for this purpose. Figs. 2 and 3 illustrate the components of the drill
press. WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE ENTIRE
INSTRUCTION MANUAL.
Fig. 2
Fig. 3
5
14
13
12
11
10
9
8
7
6
1. Drill Press Head
2. Table Bracket and Column
3. Base
4. Table
5. Chuck
6. Handles (3)
7. M8 x 125mm carriage head screws,
flat washers, lockwashers, and
hex nuts (2 ea.)
8. Locking lever for table bracket
9. Table locking lever
10. Table Raising and Lowering Handle
11. 3mm Hex Wrench
12. 5mm Hex Wrench
13. 7/16-14 x 1-3/4" Hex Head
Screws (4)
14. Chuck Key
1
2
3
4
To Next Page
Loading...
Need help?
General
