9
ATTACH HEIGHT ADJUSTMENT HANDLE
Refer to Figure 1
1. Remove the rubber cap (A) from the top of the height
adjustment crank shaft (B).
2. Use an M5 x 16mm hex head screw, M5 flat washer,
and supplied t-handle hex wrench to secure the
height adjustment handle to shaft (C).
3. Replace the rubber cap.
FIGURE 1
ASSEMBLY
FIGURE 2
A
B
C
ATTACH REVERSIBLE DUST PORT
Refer to Figure 2
The 22-555 planer features a reversible dust port that can
be attached for left-sided or right-sided dust collection.
To attach the dust port:
1. Secure the dust port (A) to the tool housing on both
ends use the two M6 x 15mm lock knobs (B).
A
B
B
CONNECTING TO DUST COLLECTOR
A planer creates a large amount of fine particles while in use. It is strongly recommended that you connect the planer to
a shop vacuum or dust collector. Your DELTA® Bench Planer is equipped with a 2” dust port that must be connected
to a vacuum hose to ensure safe operation. Using a 2" to 4" adapter, sold separately, will enable you to connect your
planer to most dust collectors that use a 4” hose.
Do not attempt to operate this tool without first connecting it to an adequate dust collection
system.
Always turn on the dust collector before starting the planer and always stop the planer before
turning off the dust collector.
To Next Page
Loading...
Need help?
General
