8
UNPACKING
UNPACKING AND CLEANING
PACKAGE CONTENTS
Carefully unpack the machine and all loose items from the shipping container. Figure 2 illustrates the planer and all loose items
supplied with your machine. Refer to the section of this manual titled “Replacing Knives” to remove the dust deflector. Remove
any rust-preventative oil from unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured
alcohol.
DO NOT use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
Take care when you clean the cutterhead. The knives in the cutterhead are very sharp. After cleaning the
cutterhead, replace the dust deflector.
This machine weighs about 75 pounds. Use a helper to lift or move it.
22-590X Portable Planer
Dust Collection Attachment
Cutterhead Height Adjusting Handle
Cutterhead Lock Handle
T-Handle T30 Torx Wrench
M6 x 20mm Torx Head Screw (6)
6.5mm x 16mm x2mm Flat Washer (4)
M6 Split Lock Washer (2)
FIGURE 2
PC1
PC1
PC2
PC2
PC3
PC3
PC4
PC4
PC5
PC5
PC6
PC7
PC8
PC6
PC6
PC7
PC8
POWER CONNECTIONS
006827
Hardware Bag 1:
Hardware Bag 2:
006846
006767
006767
When using a power tool at a considerable distance from a power source, be sure to use a 3-prong extension cord that has the
capacity to handle the current the tool will draw. An undersized cord will cause a drop in line voltage, resulting in overheating
and loss of power. Use the chart to determine the minimum wire size required in an extension cord. ONLY round jacketed cords
listed by Underwriter’s Laboratories (UL) should be used.
NOTE: Before using any extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
** Ampere rating (on total data label)
12A-16A
Cord Length Wire Size
25' 14 AWG
50' 12 AWG
** Used on 12 gauge - 20 amp circuit
NOTE: AWG = American Wire Gauge
EXTENSION CORDS
KEEP the extension cord clear of the work
area. Position the cord so that it will not get caught on lumber,
tools or other obstructions while you are working with a power
tool. Failure to do so can result in serious personal injury.
Check extension cords before each use. If damaged replace
immediately. NEVER use tool with a damaged cord, since
touching the damaged area could cause electrical shock
resulting in serious injury.
To Next Page
Loading...
Need help?
General
