Delta 36-550 User Manual

23
CONSTRUCTING A PUSH STICK
When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be
made from scrap material by following the pattern shown in Fig. 62.
Fig. 62
PUSH STICK
MAKE FROM 1/2” OR 3/4”
WOOD OR THICKNESS
LESS THAN WIDTH OF
MAT’L. TO BE CUT
CUT OFF HERE TO
PUSH 1/4” WOOD
CUT OFF HERE TO
PUSH 1/2” WOOD
NOTCH TO HELP
PREVENT HAND
FROM SLIPPING
1/2” SQUARES

Delta 36-550 Specifications

General

Brand	Delta
Model	36-550
Category	Saw
Language	English