- 1 -
………………………………………………………………… ENGLISH …………………………………………………………………
Thank you for choosing Delta DVP series PLC. DVP04PT-S is able to receive 4 points of
platinum temperature sensors and convert them into 16-bit digital signals. Besides,
through FROM/TO instructions in DVP Slim series MPU program, the data in
DVP04PT-S can be read and written. There are many 16-bit control registers (CR) in
DVP04PT-S. The power unit is separate from it and is small in size and easy to install.
a Please read this instruction sheet carefully before use.
a This is an OPEN TYPE I/O module and therefore should be installed in an enclosure
free of airborne dust, humidity, electric shock and vibration. The enclosure should
prevent non-maintenance staff from operating the device (e.g. key or specific tools
are required for operating the enclosure) in case danger and damage on the device
may occur.
a DO NOT apply AC power to any of the input/output terminals, or it may damage
DVP04PT-S.
a DO NOT touch any terminal when the power is switched on.
a Make sure that the DVP04PT-S is properly grounded , to prevent any
electromagnetic noise.
a Please keep the wires as short as possible when connecting RTD to PLC and keep
power lead as far away as possible from I/O wires to prevent noise interference.
Product Profile & Dimension
90.00
4.00
3.00
25.20
1
2
3
4
5
●
FG
L+
L-
I+
C
H
1
C
H
2
C
H
3
C
H
4
●
FG
L+
L-
I+
FG
L+
L-
I+
FG
L+
L-
I+
60.00
6
7
8
9
3
10
11
12
13
90.00
3.00
3.4
60.00
14
[ Figure 1 ]
Unit: mm
1. Status indicator (POWER, RUN and ERROR) 8. I/O module connection port
2. Model name 9. I/O module clip
3. DIN rail clip 10. DIN rail (35mm)
4. I/O terminals 11. RS-485 communication port
5. I/O point indicator 12. I/O module clip
6. Mounting holes 13. DC power input
7. Specification label 14. I/O module connection port
I/O Terminal Layout
L-L+FGL-L+
DVP04PT-S
FGI- L+FGI-L-L+ FGI-L-I-
CH1 Ch2 Ch3 Ch4
To Next Page
Loading...
Need help?
General
