Delta (Model TS220LS) User Manual

27
When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be
made from scrap material by following the pattern shown in Fig. 61.
PUSH STICK
MAKE FROM 1/2” OR 3/4”
WOOD OR THICKNESS
LESS THAN WIDTH OF
MAT’L. TO BE CUT
CUT OFF HERE TO
PUSH 1/4” WOOD
CUT OFF HERE TO
PUSH 1/2” WOOD
NOTCH TO HELP
PREVENT HAND
FROM SLIPPING
1/2” SQUARES
CONSTRUCTING A PUSH STICK
Fig. 61

Delta (Model TS220LS) Specifications

General

Brand	Delta
Model	(Model TS220LS)
Category	Saw
Language	English