1
Connect the HDMI to the AVR-5308CI with equipment
compatible with the HDMI control function.
2
Put the power on for all the equipment connected to
the HDMI.
3
Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
b Please consult the operating instructions for the connected
equipment to check the settings.
b Operations 1-3 do not have to be repeated once started.
b Carryout Operations 2 and 3 should any of the equipment be
plugged out.
4
Switch the television input to the HDMI connected to
the AVR-5308CI.
5
Switch the AVR-5308CI input to the HDMI input
source and check if the picture from the player is ok.
6
Put the television power on standby and check if the
AVR-5308CI goes into standby.
If the AVR-5308CI does not work please check the following.
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
– “Control” (vpage 33) set to “ON”?
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
– “Control Monitor” (vpage 33) set for the monitor output
connected to television?
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
– “Power Off Control” (vpage 33) set to “ON”?
• Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
• Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat Operation's 2 and 3.
•
GUI menu “Source Select” – “Assign” – “HDMI” (vpage 46)
setting has changed
•
There is a change to the connection between the equipment and
the HDMI, or an increase in equipment.
•
AVR-5308CI GUI menu “Manual Setup” – “HDMI Setup” – “Monitor
Out” (vpage 33) is changed.
Operations
Convenient Functions
HDMI Control Function
When connecting the AVR-5308CI to a television or player compatible with the HDMI control function, the following operations are
possible.
• Turn power ON/OFF (Synchronize with television)
• Switch to sound output equipment (TV and AVR-5308CI)
• Adjust volume
• Switch input source
3-
065
015*$"-
065
"6%*0
"6%*0
R
L
R
L
065
)%.*
*/
)%.*
When using these functions set as follows: GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control” (vpage 33).
Connections
Player compatible
with HDMI control
function
Television compatible with
HDMI control function
NOTE
When using the HDMI control function, do not assign HDMI input to “TV/CBL” by setting “Source Select” – “(input source)”
– “Assign” in the GUI menu.
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
AVR5308CIEU_100_初校作成中.indd 73 2008/05/26 9:42:47
To Next Page
Need help?
General
