8
AVR-2105/885 / AVC-1890
ADJUSTMENT
Audio Section
Idling Current
Required measurement equipment : DC Voltmeter
調整に必要な測定器:直流電圧計
Preparation
(1) Avoid direct blow from an air conditioner or an electric fan, and adjust the unit at normal room tempereture
15 °C ~ 30 °C (59 °F ~ 86 °F).
(2) Presetting
● POWER (Power sourse switch) → OFF
● SPEAKER (Speaker terminal) → No load (Do not connect speaker, dummy resistor, etc.)
(1)セットをクーラ、扇風機のそばなど風通しの良い場所を避け、通常の使用状態に置きます。セットの周囲温度は
15〜30℃、湿度は常湿とします。
Adjustment
(1) Remove top cover and set VR101, VR102, VR103, VR104, VR105 on Amp. Unit, VR106,107 on SURR.-BACK ch Amp.
Unit at full counterclockwise (
) position.
(2) Connect DC Voltmeter to test points (FRONT-Lch: TP104, FRONT-Rch: TP105, CENTER ch: TP103,
SURROUND-Lch:TP101, SURROUND-Rch:TP102, SURROUND-BACK Lch:TP106, SURROUND-BACK Rch:TP107).
(3) Connect power cord to AC Line, and turn power switch "ON".
(4) Presetting. MASTER VOLUME : "---" counterclockwise (
min.)
MODE : 7CH STEREO
FUNCTION : CD
(5) Within 2 minutes after the power on, turn VR101 clockwise (
) to adjust the TEST POINT voltage to 1.5 mV ±0.5 mV
DC.
(6) After 10 minutes from the preset above, turn VR101 to set the voltage to 2.5 mV ±0.5 mV DC.
(7) Adjust the Variable Resistors of other channels in the same way.
(1)上カバーをはずし、パワーアンプ基板のVR101,VR102,VR103,VR104,VR105及びSurr.Backアンプ基板のVR106,107を
反時計方向( )に回し切った状態にセットします。
(2)テストポイント(FRONT‑Lch: TP104, FRONT‑Rch: TP105, CENTER ch: TP103, SURROUND‑Lch: TP101,
SURROUND‑Rch:TP102,SURROUND‑BACKLch:TP106,SURROUND‑BACKRch:TP107)に直流電圧計を接続します。
(3)電源コードをAC100V(95〜105Vの範囲でも可)に接続し、電源スイッチを"ON"にします。
(4)ON後、次のようにセットします。
●VOLUME(音量調節つまみ)→反時計方向( )に回す、最小の状態にする。
●SPEAKER‑A(スピーカ端子)→無負荷(スピーカ、ダミー抵抗器などを接続しない。)
MODE:7CHSTEREO
FUNCTION:CD
(5)2分以内にVR101を時計方向(
)に回しテストポイントの電圧を次のように調整します。
1.5mV±0.5mVDC
(6)予備調整から10分後VR101を回し、次のように電圧を設定します。
2.5mV±0.5mVDC
(7)同じ方法で各チャネルの可変抵抗を調整します。
VR104
TP104
VR105
TP105
VR107
VR106
TP107
TP106
S BR
S BL
S Rch
VR102
TP102
VR103,TP103
C ch
VR101,TP101
F Lch
S Lch
F Rch
DC Voltmeter