o
CONNECTIONS
• Do not plug in the power cord until all connections have
been completed.
• Be sure to connect the left and right channels properly (left
with left, right with right).
• Insert the plugs securely. Incomplete connections will
result in the generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
• Note that binding pin plug cords together with power cords
or placing them near a power transformer will result in the
introduction of hum or other noise.
• If hum or other noise is produced when the ground wire is
connected, disconnect it.
• Noise or humming may be generated if a connected
component is used independently without turning the
power of the AVR-2500 on. If this happens, turn on the
power of the AVR-2500.
2-1 Connecting the audio components
NOTE:
The receiver cannot be used with
Me
cartridges directly. Use a
separate head amplifier or step-
up transformer.
Turntable (MM cartridgei
,..------,
Center speaker
A B
a a
Use these jacks when using another
pre-main amplifier or a separate
amplifier.
I
'. I
Ll
-+---_i_,lJ
f-'
6 ~.
WR
z ~
::J~
; co
player
IlL: ·
Tape deck or OAT
o
NTENNA
ERMINALS
(IT)
.fl'F\ ~
~ \JJI "
EjgOO
(jJ)
Multi source
pre-main amplifier
Another room
• Precautions when connecting speakers
If
a
speaker is placed near a TV or video monitor, the colors on the
screen may be disturbed by the speaker's magnetism. If this should
happen, move the speaker away to a position where
it
does not have
this effect.
Rear speaker
R L
~
I
I
POWER OUTLET
AC 120V. 60Hz
(North America model
I
AC 115V/230V, 50/60Hz
I(MUlti
Voltage
modell
Main speaker A
(Front)
Main speaker B
(Fronti
Connection jack for sub-
woofer
with
built-in
amplifier
(super woofer). etc.
5
To Next Page
Loading...
Need help?
General
