41
9
OPERATION
Before operating
1
Refer to “CONNECTIONS” (pages 6 to 13) and check that all
connections are correct.
2
Select “AMP” using the RECEIVER button.
(only when operating with the remote control unit)
3
Turn on the power.
Press the POWER switch (button).
When pressed, the power turns on and the display lights. The sound
is muted for several seconds, after which the unit operates normally.
When pressed again, the power turns off, the standby mode is set
and the display turns off.
Whenever the ON/STANDBY button is in the STANDBY state, the
apparatus is still connected on AC line voltage. Please be sure to
unplug the cord when you leave home for, say, a vacation.
(Remote control unit)
To Next Page
Loading...
Need help?
General
