Getting Started Playback Remote Control Information Troubleshooting Specifications
ENGLISH
Multi-ZoneSettings
Protection circuit
If the core wires touch the rear panel and the screws
etc., or the ± sides touch each other, the protection
circuit will be activated and the power indicator will
flash red at intervals of 0.5 secs.
If the protection circuit is activated, the speaker
output is isolated, and the power supply goes to
the standby state. If the power supply is turned off,
after the power supply cord is withdrawn, please
confirm that speaker cable and input cable are
connected.
Also, if replaying large sound levels by using
a speaker having an impedance less than that
specified (eg, 4 Ω/ohms), the temperature will rise,
and the protection circuit might be activated. The
power supply will go into the standby state, and the
power indicator will flash red at 2 second intervals.
In this case, please switch off the power supply,
and wait until the AVR-790 has cooled down, and
the surrounding ventilation is good.
Even if there are no problems with the surrounding
ventilation and connections, in the event of the
protection circuit becoming activated,
due to thinking that the AVR-790 has failed, please
contact DENON Service center after switching off.
w q
w q w q
*/
(L) (R)
w qw q
(R) (L)
Subwoofer with
builtin amplifier
Center
speaker
Surround
speakers
Front
speakers
For connections of the SURR. BACK/AMP
ASSIGN speaker terminals, see “Amp Assign”
(vpage 25).
Connecting the Speakers
s
Set the “Amp Assign” Mode According to the Speaker Layout.
The signals output from the AVR-790’s SURR. BACK/AMP ASSIGN speaker terminals can be
switched to signals of the surround mode being used (vpage 25 “Amp Assign”).
Amp assign mode
(vpage 25)
SURR. BACK/AMP ASSIGN
Speaker connections
Example of speaker installation
Normal
Normal
Normal
Front Height
Front Bi-Amp
ZONE2
(Default)
MAIN ZONE ZONE2
Front Height
speakers
Surround back
speakers
Surround back
speakers
Not connected
Front
speakers
ZONE2 speakers
b For connections,
see “About bi-amp
connections”
(vpage 12).
(7.1)
(6.1)
(5.1)
(7.1)
(5.1)
(5.1)
(2)
b Connect to the “L”
speaker terminal.
b Set “Surround Back”
(vpage 26) to “1spkr”.
b Set the “Surround Back”
setting (vpage 26) to
“OFF”.
Connections
Installing/Setting the Speakers
To Next Page
Loading...
Need help?
General
