Denon AVR-884 User Manual

43
14
SURROUND
Before playing with the surround function
• Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment
can be performed with the system setup (see page 20) or from the remote control unit, as described below.
• Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and only effective in the DOLBY/DTS
SURROUND modes. The adjusted levels for the different modes are automatically stored in the memory.
1
Set the DOLBY/DTS SURROUND modes.
2
Press the TEST TONE button.
(Main unit) (Remote control unit)
(Remote control unit)
1
3
2, 4
3
1
3
Test tones are output from the
different speakers. Use the channel
volume adjust buttons to adjust so
that the volume of the test tones is
the same for all the speakers.
(Remote control unit)
4
After completing the adjustment, press
the TEST TONE button again.
(Remote control unit)
ENGLISH

Denon AVR-884 Specifications

General

Brand	Denon
Model	AVR-884
Category	Stereo Receiver
Language	English