Denon AVR-X5200W User Manual

o
Desired sound does not come out
Symptom Cause / Solution Page
The volume does not
increase.
0
The maximum volume is set too low. Set the maximum volume using “Limit” on the menu. 189
0
Appropriate volume correction processing is performed according to the input audio format and settings,
so the volume may not reach the upper limit.
－
No sound comes out with
the HDMI connection.
0
Check the connection of the HDMI connectors.
63
0
When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “AVR”. To output
from the TV, set “TV”.
199
0
When using the HDMI control function, check that the audio output is set to the AV amplifier on the TV. 161
No sound comes out of a
specific speaker.
0
Check that speaker cables are properly connected.
40
0
Check that a selection other than “None” is set for the “Speaker Config.” setting in menu. 241
0
Check the “Assign Mode” setting in the menu. 224
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and subwoofer. －
No sound is produced from
subwoofer.
0
Check the subwoofer connections.
41
0
Turn on the subwoofer’s power. －
0
Set “Speaker Config.” - “Subwoofer” in the menu to “1 spkr” or “2 spkrs”.
241
0
When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the
sound mode, no sound may be output from the subwoofer.
241
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the
subwoofer.
249
0
You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”. 249
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”. －
0
Set “Decode Mode” on the menu to “Auto” or “DTS”.
212
Dolby Atmos, Dolby
TrueHD, DTS-HD, Dolby
Digital Plus audio is not
output.
0
Make HDMI connections. 67
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by
default.
－
Contents Connections Playback Settings Tips Appendix
285
Front panel Display Rear panel Remote Index

Denon AVR-X5200W Specifications

General

Receiver type	Surround
Frequency range	20 - 20000 Hz
Output impedance	16 Ω
Speaker selector	A+B
Pre-out connectivity	Yes
Audio output channels	- channels
Power output per channel (1KHz@6 Ohm)	205 W
Power output per channel (20-20KHz@8 Ohm)	140 W
HDMI in	8
Remote (IR) input	1
Composite video in	5
Component video (YPbPr/YCbCr) in	2
Number of HDMI outputs	3
Connectivity technology	Wired & Wireless
Speakers connectivity type	-
Audio formats supported	AAC, AIFF, FLAC, MP3, WAV, WMA
Image formats supported	JPG
Supported radio bands	AM, FM
Internet radio services supported	Spotify, vTuner
Optical drive included	No
Product color	Silver
Audio decoders	Dolby TrueHD, DTS 96/24, DTS Neo:X, DTS-ES, DTS-HD Master Audio
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	730 W

Weight and Dimensions

Depth	393 mm
Width	434 mm
Height	167 mm
Weight	14200 g