Denon SYS-A3L User Manual

12
ENGLISH
(1) Connecting the line input connector (LINE IN)
* Connect this to the pre-out connector for the active subwoofer on the AV amplifier (“SUBWOOFER PREOUT”,
“MONO OUT”, etc.) using the included connection cord (3-meter RCA pin cord).
MASTER VOLUME
PHONES
TONE CONTROL TUNING STATUS SURROUND MODE
DOLBY
/DTS SURROUND
BAND
AV SURROUND RECEIVER AVR-770SD
AUTO
PCM DTS
INPUT MODE
FUNCTION / SELECT
SIGNAL DETECT
SURROUND BACK
OUTPUT
DIRECT
/STEREO
5ch/6ch
STEREO
DVD
AUTO
DIG
DIGITAL
STANDBY
ON / STANDBY
CAUTION:
• If this connector is connected to the pre-out connector for the surround center channel of a stereo amplifier or
AV surround amplifier, only the center channel’s bass sound will be produced, so the overall bass sound will be
insufficient.
CAUTION:
• Do not plug the AC power cord into an AC power outlet until all connections have been completed.
• Check the left and right channels and be sure to interconnect them properly, L (left) to L, R (right) to R.
• Plug the AC power cord in securely. An insecure connection could cause noise.
• Note that clamping pin-plug cords and power cords together or running pin-plug cords near the power
transformer could result in humming or noise.
• Check the polarities of the speakers and amplifier and be sure to interconnect properly. Connect the red
terminal on the speaker to the “+” speaker terminal on the amplifier, the black terminal on the speaker to the
“–” speaker terminal on the amplifier.
CONNECTIONS
Active subwoofer (DSW-3L)
Included connection cord
(3-meter RCA pin cord)

Denon SYS-A3L Specifications

General

Brand	Denon
Model	SYS-A3L
Category	Stereo System
Language	English