DeWalt DCE079G User Manual

35
ENGLISH
4. Mark and measure points A and B on the walls as shown in
Figure O.
5. Turn the entire laser unit 180º so the X-axis points directly
toward the opposite wall.
6. Allow the laser unit to self-level, and mark and measure
points AA and BB on the walls as shown in FigureP.
7. Calculate the total error using the equation:
Total Error = (AA – A) – (BB– B)
8. Compare total error to the allowable limits shown in the
following table.
Distance between walls Allowable Error
L = 15 m 3 mm
L = 25 m 5 mm
L = 50 m 10mm
Level Calibration Check (Y-axis)
Repeat the procedure above, but with the laser unit positioned
so the Y-axis is pointed directly toward the walls.
Plumb Error Check (Fig. Q)
1. Using a standard plumb bob as a reference, mark the top
and bottom of a wall. (Be sure to mark the wall and not the
floor and ceiling.)
2. Position the rotary laser securely on the floor approximately
1 m from the wall.
3. Turn the laser on, and point the dot at the mark on the
bottom of the wall. Then, using the up/down arrows on the
remote control, rotate the dot upwards. If the center of the
dot scans over the mark on the top of the wall, the laser is
properly calibrated.
NOTE: This check should be done with a wall no shorter than
the tallest wall for which this laser will be used.
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
Batteries
When disposing batteries, think of the protection of the
environment. Check with your local authorities for an
environmentally safe way of battery disposal.
Batteries
Chargers/Charge Times (Minutes)
Cat #
DC
Weight
Batteries Chargers/Charge Times (Minutes)
Cat # V
DC
Ah
Weight
kg
DCB107 DCB113 DCB115 DCB118 DCB132 DCB119 DCB413
DCB546 18/54 6.0/2.0 1.05 270 140 90 60 90 X X
DCB547 18/54 9.0/3.0 1.25 420 220 140 85 140 X X
DCB497 36 7.5 1.92 X X X X X X 150
DCB496 36 6.0 1.88 X X X X X X 120
DCB181 18 1.5 0.35 70 35 22 22 22 45 X
DCB182 18 4.0 0.61 185 100 60 60 60 120 X
DCB183/B 18 2.0 0.40 90 50 30 30 30 60 X
DCB184/B 18 5.0 0.62 240 120 75 75 75 150 X
DCB185 18 1.3 0.35 60 30 22 22 22 X X

DeWalt DCE079G Specifications

General

Brand	DeWalt
Model	DCE079G
Category	Laser Level
Language	English