IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT
THIS OR ANY D
eWALT TOOL, CALL US TOLL FREE AT:
1-800-4-D
eWALT (1-800-433-9258)
Important Safety Instructions
WARNING: Do not operate this unit until you read and understand
this instruction manual and the engine instruction manual for safety,
operation and maintenance instructions.
WARNING: When using this product basic precautions should
always be followed, including the following:
1. Read all instructions before using the product.
2. To reduce the risk of injury, close supervision is necessary when
a product is used near children.
3. Know how to stop the product and bleed pressures quickly. Be
thoroughly familiar with the controls.
4. Stay alert–watch what you are doing.
5. Do not operate the product when fatigued or under the influence
of alcohol or drugs.
6. Keep operating area clear of all persons.
Definitions: Safety Guidelines
The definitions below describe the level of severity
for each signal word. Please read the manual and
pay attention to these symbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death
or serious injury.
WARNING: Indicates a potentially hazardous
situation which, if not avoided, could result in death
or serious injury.
CAUTION: Indicates a potentially hazardous
situation which, if not avoided, may result in minor
or moderate injury.
CAUTION: Used without the safety alert symbol
indicates a potentially hazardous situation which, if
not avoided, may result in property damage.
Specifications
MODEL WEIGHT HEIGHT WIDTH LEnGTH PSI MAx* AVERAGE
OPERATInG
PSI
GPM MAx* AVERAGE
OPERATInG
GPM
EnGInE
DPD3000IC 83.6 lbs 26.5" 23" 40" 3000
(20384 kPa)
2750
(18961 kPa)
2.8
(10.6 L/min)
2.7
(10.3 L/min)
DeWALT
196 cc OHV,
5.5 Net HP, 6.5
Gross HP **
* Maximum PSI and GPM ratings determined in accordance with the Pressure Washers Manufacturers Association (PWMA)
standard PW101
** Horsepower rating (shown as maximum output @ 3600 rpm) is in accordance with SAE J1349 for Net HP and SAE J1995 for Gross HP.
Actual engine power will be lower. Engine power depends on the application, operating speed, operating conditions and other variables.
To Next Page
Loading...
Need help?
General
