Consult the engine instruction manual for the man u fac tur er's
recommendations for storage.
The manufacturer recommends using a pump protector/winter-
izer, such as D
eWALT winterizer (DP80) when storing the unit
for more than 30 days and/or when freezing temperatures are
expected. D
eWALT winterizer (DP80) is availabe at the store
where the pressure washer was purchased. If a pump protector/
winterizer is not available, RV antifreeze can be used as outlined in
the following steps.
NOTE: Using a pump protector/ winterizer or RV antifreeze helps to
provide proper lubrication to the internal seals of the pump regard-
less of temperature or environment.
1. Obtain a funnel, 6 oz. (170 mL)
of RV antifreeze and 16–36" (40–
91cm) of garden hose with a
male hose connector attached to
one end.
CAUTION: Risk of property damage.
an ti freeze is corrosive and can dam-
age pump.
2. Disconnect spark plug wire.
3. Connect length of garden
hose to water inlet of pump.
4. Add RV antifreeze to hose as shown.
5. Pull engine starter rope slowly several times until an ti freeze
comes out of high-pressure hose con nec tion of pump.
6. Remove garden hose from water inlet of pump.
7. Reconnect spark plug wire.
1. Drain all water from high-
pressure hose, coil it and store it
in cradle of the pressure washer
handle.
2. With nozzle pointed down and
the spray gun and wand in a
vertical position, squeeze trigger
to drain all water from spray gun
and wand. Store in gun holder.
3. Store chemical hose so it is protected from dam age.
4. If space is needed, handles may be removed and attached as
shown.
CAUTION: Risk of personal injury. Avoid placing hands between
handle and frame when assembling to prevent pinching.
CAUTION: Risk of property damage. Always store and transport unit
in an upright position.
Recommended accessories for use with your tool are available for
purchase from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, please con-
tact D
eWALT Industrial Tool Co., 701 East Joppa Road, Baltimore,
MD 21286, call 1-800-4-D
eWALT (1-800-433-9258) or visit our web-
site www.dewalt.com.
To Next Page
Loading...
Need help?
General
