10
English
To Adjust Regulator:
Turn knob clockwise to increase regulated pressure and
counterclockwise to decrease regulated pressure.
WARNING: Risk of Bursting. Too much air pressure causes
a hazardous risk of bursting. Check the manufacturer’s
maximum pressure rating for air tools and accessories.
The regulator outlet pressure must never exceed the maximum
pressure rating.
AIR COMPRESSOR PUMP
The pump compresses air into the air tank. Working air is not available
until the compressor has raised the air tank pressure above that
required at the air outlet.
MOTOR OVERLOAD PROTECTOR
The motor has a thermal overload protector. If the motor overheats for
any reason, the overload protector will shut off the motor. The motor
must be allowed to cool down before restarting. To restart:
1. Set the Auto/Off switch to “Off (O)” and unplug unit.
2. Allow the motor to cool.
3. Plug the power cord into the correct branch circuit receptacle.
4. Set the Auto/Off switch to “Auto (-)”.
INSTALLATION
Assembly (Fig. 1)
Unpack the air compressor. Inspect the unit for damage. If the
unit has been damaged in transit, contact the carrier and
complete a damage claim. Do this immediately because there are
time limitations to damage claims.
The carton should contain:
• Air compressor, air filters, wheels with mounting hardware
and front isolators with hardware
• Operator and parts manuals
Check the compressor’s serial label to ensure that you have
received the model ordered, and that it has the required pressure
rating for its intended use.
FITTING THE WHEELS (FIG. 1)
1. Lay unit handle side down on flat, smooth surface.
2. Insert the bolt through the wheel and bracket as shown in
Fig.1.
3. Place flat washer on bolt. Holding the locking nut in place with
a wrench, tighten the wheel bolt securely.
4. Repeat these steps for the opposite wheel.
FITTING THE BUMPERS (FIG. 1)
1. Insert the bolt through the bumper and bracket as shown in
Fig. 1
2. Place flat washer on bolt. Holding the locking nut in place with
a wrench, tighten the bumper bolt securely.
3. Repeat these steps for the opposite bumper.
To Next Page
Loading...
Need help?
General
