EasyManuals Logo
Home>DeWalt>Pressure Washer>DXPW3425

DeWalt DXPW3425 User Manual

DeWalt DXPW3425
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
English
5. Direct water supply into spray nozzle to back flush loosened
particles for 30 seconds.
6. Reassemble the nozzle to the wand.
7. Reconnect spray wand to gun then turn on water supply.
8. Start pressure washer and place spray wand into high pressure
setting to test.
To Clean the Water Inlet Filter (Fig. 10)
This filter screen (U) should be checked periodically and cleaned if
necessary.
1. Remove the filter screen (U) by grasping the end and removing it
from water inlet of pump.
2. Clean filter by flushing it with water on both sides.
3. Reinsert filter into water inlet of pump. C
onvex
side faces out.
NOTE: Do not operate pressure washer without filter properly
installed.
STORAGE
Engine
Consult the engine instruction manual for the man u fac tur er's
recommendations for storage.
Pump
The manufacturer recommends using SIMPSON
®
/ POWERWASHER
®
Pump Guard or equivalent when storing the unit for more than 30
days and/or when freezing temperatures are expected. SIMPSON
®
/
POWERWASHER
®
Pump Guard is environmentally friendly.
NOTE: Using pump guard helps provide proper lubrication to the
internal seals of the pump regardless of temperature or environment.
NOTICE: Risk of property damage. Use only SIMPSON
®
/
POWERWASHER
®
Pump Guard or equivalent. Other products could
be corrosive and/or contain alcohol which may cause pump damage.
1. Turn off pressure washer and disconnect hoses from pump.
2. Unscrew bottle valve from Pump Guard bottle and remove seal.
3. Screw bottle valve back onto bottle.
4. Attach bottle to water inlet of pump.
5.Squeezebottletoinjectcontentsintopump.
6. With ignition switch off, simultaneously pull starter rope and
squeeze bottle. Repeat until protector fluid exits pump outlet.
NOTE: Thisstepmayrequiretwopeople.
Pressure Washer
1. Drain all water from high pressure hose, coil it and store it in
cradle of the pressure washer handle.
2. With nozzle pointed down and the spray gun and wand in a
verticalposition,squeezetriggertodrainallwaterfromspraygun
and wand. Store in gun holder.
3. Store chemical hose so it is protected from dam age.
CAUTION: Risk of personal injury. Avoid placing hands between
handle and frame when assembling to prevent pinching.
NOTICE: Risk of property damage. Always store and transport unit
in an upright position.
ACCESSORIES
Recommended accessories for use with your tool are available for
purchase from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, please contact
the FNA Group at www.dewaltpw.com, 1825 Greenleaf Avenue, Elk
Grove Village, Il 60007, or call (877) FNA-GAS1.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DeWalt DXPW3425 and is the answer not in the manual?

DeWalt DXPW3425 Specifications

General IconGeneral
BrandDeWalt
ModelDXPW3425
CategoryPressure Washer
LanguageEnglish

Related product manuals